Description
-
Starting motion LED flexible tape...Short (1)
■Product image
-
Starting motion LED flexible tape...Short (2)
-
Starting motion LED flexible tape...Short (3)
-
Starting motion LED flexible tape...Short (4)
■Lighting motion image
-
Starting motion LED flexible tape...Short (5)
-
Starting motion LED flexible tape...Short (EX1)
-
Starting motion LED flexible tape...Short (EX2)
■White
-
Starting motion LED flexible tape...Short (EX3)
■Blue
-
Startup motion LED flexible tape...Short (EX4)
■Light blue
- Item Number:
- OLEDTS-BLU～OLEDTS-WH
Starting motion LED flexible tape short motion
LED tape that turns the headlights of the new 60 Prius into single-character lights like the new Crown. Furthermore, when the lights start, it is equipped with a light-emitting motion in which the LEDs flow like a scanning line, and the scanning effect at startup, just like a robot animation, stylishly appeals to the vehicle's startup. Short motion type with only about 2 seconds of lighting scan motion.
specification
Tube material: waterproof silicone
Total length: approx. 1500mm (1.5m)
Width:: Approx. 14mm
General purpose 12V
*Please be sure to check the lighting status and electricity before installation.
*Since it is flexible, it can be bent freely, but if you bend it repeatedly or handle it strongly, the LED inside may break.
Please be careful not to bend it more than necessary, reinstall it repeatedly, or handle it roughly.
*The double-sided tape included with the product is for exterior use, but it is not as durable as 3M's double-sided tape.
Please install it in a place where it will not fall off even if it comes off while driving, such as inside the hood or inside the door, or use 3M double-sided tape separately if necessary.
*It can be cut in the same way as regular LED tape, but the intersection/origin point of the LED light emission will not be in the center. (Still in the center position before cutting)
Please note that due to the above reasons, product warranties cannot be covered after double-sided tape has been applied.
Thickness:: Approx. 4mm (one side double-sided tape)
Voltage: for 12V
Wiring: (+) Connect to ACC, etc. (-) Ground
motion pattern
Left and right reciprocating slide lighting (scanning line scanning effect lighting)
flashes 3 times
Lights up sequentially from the center
All lights on (lighting of headlights is not a product function)
*By connecting to ACC, the LED lighting motion will start when the vehicle starts.
This is not the opening light, opening action, or lighting when the door is unlocked.
The thin flexible tube allows it to be set in small gaps or along the body radius.